Who owns the battery?
Ask the vendor.
A shorter thread length is sometimes used where wall thickness is limited, or when space is needed for plumbing beyond the threads.
Your picture is too fuzzy to see much, but they're punched. Sometimes with a custom punch for the hole shape, sometimes nibbled with a smaller...
It's not really possible to make a truly sharp corner at the bottom of the groove, so you might as well make it radiused per the spec. At the...
When I was freelancing, most of my customers came from word of mouth from other customers, but I did get some work by reading job ads. Often a...
It doesn't deserve any more than a "quickie", since it takes no analysis for it to be obvious to anybody with an understanding of basic physics...
The first is part of the helix angle: 22 degrees 58 minutes 19 seconds or 22.9719444°. TDP is transverse diametral pitch. I'm guessing the...
Well, first you need to know, or make some assumptions, about how and where the person's weight is distributed across the top plate. Given the...
We have evaluated it and quickly concluded that it won't work. As for the post you were responding to, I hate to break it to you but it was a...
[IMG]
Well, you posted it in the section that's supposed to be for forum announcements. I didn't watch your video, but if it's making noise the...
It will depend on the elastic modulus of the ball and the taper angle and surface finish of the restriction. Might just be easier to test it.
If it's always turning in the same direction, a drag brake on the output might do it. Zero backlash gearboxes are also a thing, though whether...
Unless it's spinning really fast so rotor inertia is an issue and the brush hits a sudden hard stop, it's not likely the motor torque is...
Separate names with a comma.
▲
