Might be a good idea to actually tell people WHERE in England the job is.
Why is Iron the only metal that can be magnetic ? Why only Iron ? What if no one yet had discovered that Iron can be made magnetic, There would...
Perhaps the machine worked. When PaulT started it, he was transmuted into a block of energy dark matter and instantly transported to the centre...
These will be standard stock size ball bearings. Press them out of the casing and measure them. They will be something similar to > 32 diameter...
Hello to Alexei in Russia !
What's the 'kin question ?
What about this ........ https://www.youtube.com/watch?v=TzsqU8YG_iY
Hello Bob, I'm a Solidworks designer, and a Chocoholic. If you can send your drawing/s by email, I will make up a 3D model / picture for you to...
. I have very little money at the moment as I took a £1500 loan to get the device further because I am so dedicated to proving if the...
. You sure have put a lot of work and effort into this ! Hope that you get some good results out of it.
This is a trick question ! The loads are completely irrelevant. Just copy that sketch, so that it shows the centre of the ball is 40 mm above...
Are you trying to seal a liquid under pressure ? Any pressure will leak into the gap all the way down the bore and try to force the two alloy...
You can't just buy the parts, you will have to get them made. Someone will have to design them. Each die mold set will cost about $ 6000, and...
[/COLOR] These parts shown in the photos are not machined ...... They are Zinc Alloy pressure die-castings. Moulded by the...
Separate names with a comma.
▲