• Welcome to engineeringclicks.com

    • Recent Content by nina

    1. nina
      Post

      Low Quantities of Material for Prototyping

      Hi ,Callmecy We can do rapid ptotoype as small quantities ,Could you send drawing to me for quoting
      Post by: nina, Aug 27, 2015 in forum: Manufacturers of mechanical parts
    2. nina
      Post

      Plastics for moulding help

      PPS is very expensive , I think PPMA is ok
      Post by: nina, Aug 17, 2015 in forum: Plastic moulding
    3. nina
      Post

      Texture of injection moulding

      Mold-tech and YS (Yick Sang) we used usually
      Post by: nina, Aug 14, 2015 in forum: Plastic moulding
    4. nina
      Post

      Info on creating a Mould

      reply to gchiham (info on creating a mould ) Would you mind surface finish? generally injection mold process will have good preformance , vacumm...
      Post by: nina, Aug 14, 2015 in forum: SolidWorks
    5. nina
      Post

      Info on creating a Mould

      Would you mind surface finish? generally injection mold process will have good preformance , vacumm and rotational is hard to control surface...
      Post by: nina, Aug 14, 2015 in forum: SolidWorks
    6. nina
      Post

      POLL: How did you find EngineeringClicks?

      I find it from linkedin
      Post by: nina, Aug 14, 2015 in forum: Pop in and say hello!
    7. nina
      Post

      POLL: So where's everyone from?

      Hi ,This is Nina from China
      Post by: nina, Aug 14, 2015 in forum: Pop in and say hello!
    8. nina
      Post

      Welcome to the Mechanical Design Forum

      Hi ,Everyone , It is nina from Chinese who is a mould designer
      Post by: nina, Aug 14, 2015 in forum: Pop in and say hello!

    ▲

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Accept Learn More.
      Dismiss Notice