The World is but One Family !
I would recommend SolidEdge 2D. It is from Siemens and is Free. It is Parametric and very intuitive too. One can even tryout various 2D mechanisms...
Oh No! Thanks for the advice.
You are looking at ONE cycle. Dv/dt though cosine, is negative max at the end of the cycle and positive max at the beginning of next cycle. To...
Here one can see all the motion profiles and the infinite jerk at the ends for SHM though momentary. The acceleration though following a cosine...
Motion being a SHM, when we differentiate the motion thrice (First for Velocity, second for Acceleration, third one for Jerk or Rate of change of...
Not a good mechanism. The motion being sinusoidal, you will get infinite jerk at the direction reversals. I would prefer a grooved face cam with...
It is not at all difficult to use. Try the new Creo. It has the new ribbon interface (personally I dislike it) and is far far superior to SW or...
The above is valid with a slight modification in the process. * Rename the drawing to def.drw *Create a NEW part (say pqr.prt)using def.prt as a...
I don't know the kind of data you have. However, if you have the data in Excel, one can mail merge the same by building an invoice format. What a...
I would have been in the hospitality industry. I always wanted to be a Chef!!!
Gear Shaving could be an option. Since the module is small, you may even try Electrochemical machining, though I am not sure about the accuracy...
Separate names with a comma.
▲
