• Welcome to engineeringclicks.com

    • Recent Content by sushilshinge

    1. sushilshinge
      Post

      Twist Angle in Valve

      Actually, In the design already I have, twist angle 0.25 deg./m is taken. But it is used in Tooling. That is why i was confused.
      Post by: sushilshinge, Jan 19, 2013 in forum: Calculations
    2. sushilshinge
      Thread

      Output torque required to run sand mixer..

      Hello Dear Friends !!!! I want to design gearbox for sand mixer.But I want to calculate output torque require to run mixer. Please search image...
      Thread by: sushilshinge, Jan 16, 2013, 2 replies, in forum: Calculations
    3. sushilshinge
      Thread

      Spur Gears Simulation

      Hi Friends !!! I have drawn the gears in CATIA V5. Now I want to simulate them.I tried so much.Two DOF remain at last. Which constraints are to...
      Thread by: sushilshinge, Jan 13, 2013, 0 replies, in forum: 2D and 3D CAD general discussion forum
    4. sushilshinge
      Thread

      Twist Angle in Valve

      Hello Friends !!!! I want to design a valve operating worm gearbox. The output shaft is to be designed on the basis of Torsional rigidity.So...
      Thread by: sushilshinge, Jan 12, 2013, 3 replies, in forum: Calculations

    ▲

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Accept Learn More.
      Dismiss Notice