There are two ways that you can tackle your design. You can design every part of your assemble, size items where necessary through calculation and...
Your system will not work. If you need a drive as illustrated then gear T2A or T2B needs to be, say double width and the lower T3 off set to miss...
Rumbling has principally been used for many years to remove burrs from components which in itself can be a very time consuming and therefore...
Not quite sure what you are after, you need to decide which type of spiral bevel system you want to design, Klingelnberg palloid spiral or the...
There are many factors that can induce and affect gear noise. Geometrical inaccuracy of the gears being the main cause of noise. ie: pitch...
You will need to watch the tolerances of the spacer parts in order to obtain pressure between the battery tabs.
A simple labyrinth seal with compressed air supply to the bearing side of the seal.
Check out the TUFNOL range, probably CARP BRAND will do. http://www.tufnol.com/tufnol/default.asp?id=26
At college, in the early 60's we were taught in the imperial system but all the companies I have worked in have used the metric system. I still...
"Should a Mechanical Design Engineer know everything about everything?" ......No but a good designer will know what he doesn't know and where to...
Machine Guarding
The gear setup is a sun and planet system, the sun gear is the center one and the planet gears are the larger outer ones. To convert the...
There are various ways to achieve what you are after with regards to the drive depending upon the complexity required and the cost. Are the...
As you are using small diameter shafts you don't have much option as to the many types of gear fixations possible. With the torque figures...
Separate names with a comma.
▲
