To obtain that accuracy you cannot rely on the thread alone, you will need a shoulder that locates into a registration recess.
The problem with using galvanized steel is, if you have to cut it, it will rust on the edges. You can get cold galvanising paint but it's not as...
See here: http://www.pwromex.com.pl/katalogi/bimba/FL_ISO.pdf
Most manufacturers supply mounting accessories as you describe.
If the cylinder is to an international standard, any manufacturers...
How much load will the assembly have to take?
Is part 2 hollow or solid, if hollow, what is the wall thickness?
I can't see the details from your images, is there enough clearance between the barrel and the tie rods to put a tubular spacer over the tie...
You could use a Tollock type bush https://www.rexnord.com/Products/PT-Drive-Components/Locking-Devices/Medium-Torque/TLK134
They don't need a...
I suggest a SUN hydraulics valve Part No. RPECLEN-FEV
If you're going to use it with water, I recommend using a stainless steel body option /AP...
What pressure do you require and at what flow rate.
The PRV will provide a stable pressure independent of flow rate changes.
A restrictor valve would work but it would not provide a stable pressure...
The check valve inlet pressure will be what the relief valve is set at.
If your check valve opens at 6 Bar, initially set the relief valve lower,...
Your circuit is correct.
The pump must be able to supply a flow rate much higher than the expected maximum flow rate of the check valve.
I suggest you use a fixed displacement pump which will deliver a higher flow rate than you require.
Use a relief valve to adjust the pressure,...
What fluid are you using, I guess water if you're proposing to use a centrifugal pump.
What type of tests do you want the rig to perform?
Hydraulic Cylinder Rod material is available hard chrome plated and finished to size.
The (Extrusion) Gap between the Rod diameter and the...
There's a bit more to it than that.
You want the valve to stay fully closed until the opening pressure is reached and then open as wide as...
Does the frame have to be non magnetic?
It might be more cost effective to have it manufactured in one piece of steel, laser marked and folded.
I'm guessing that they are geared motors, if so, the gearboxes might be worn and need differing amounts of torque to run without load. One might...
It's hard to tell, but it looks like it's driving the chain at slow speed through a gearbox, this would indicate that it's not driving the...
A normal hydraulic quick release coupling (as in the Google images link) uses the knurled sleeve to hold it coupled. It holds a ring of...
Separate names with a comma.