Hello, Being moved out of my material comfort zone and into fluids after a job change; and in need of some basic advice. we have a pneumatic...
at what temperature ?...
no, your are faced with dimensional limits. As CPPMable says, go back to basics - at 60mm deep that is the limiting factor that defines the...
you mean use an I beam with web cutouts ? interesting masters dissertation on wooden composite beams with cuts outs...
just to be clear, you need to put a square hole into something or you need to make an external profile square and what is the material ? assuming...
the maximum strength of the cable is a material property and is the point at which the pressure within the cable exceeds its elastic capacity. if...
I would use Shackles or Carabiners tony
Hello there, I need to count the motion of a cylinder on a press, needs to be a mechanical count rather then electrical due to storage time of...
Hi peter, why knurl the part if you want torque transmission ? much simpler to have a plane surface and an intemperance fit. tony the link...
The graphics card should be always first suspect ! check it against the solid works list of certified cards and make sure your driver is upto...
Dowels. Drill, them ream locating dowel holes in the base and then set dowels into the blocks, you'd only need two per block to restrain them...
Mine is an old space navigator :( you'd better put me in the draw for the sexy new one :) tony
Well, actually this charity does. http://www.justgiving.com/Sophies-wish Lisa is a close family friend and her 8yr daughter has been diagnosed...
how do you change it ? I've never found the setting !
this another intrestring link sorry, mine was the same link ! so I'll pint you here instead...
yes - but not everyone likes them and they take a little getting use to them. My only real real grip is that it spins my Solidworks model from a...
good points all round. We have an old Cincinnati machine and we've been using Cadlink quite happily for basic 2D profile's, and as part of a...
me thinks you're looking for the holy grail of all engineers - the one reference book that will guide you through a difficult and complex subject...
The majority of CV's that cross my desk are of candidates with Msc's/M.Eng, and I.MechE now reqire an Msc to fulfil their comptance requirements....
thanks for that, I'll have a look at the website and let you know tony.
Separate names with a comma.
▲
