My intent was to get you thinking about pertinent questions the valve actuator must operate within. I know you mentioned the fluid in this case is...
Ball Valve Actuation I believe there are commercially available worm drive actuators that utilize either a DC or AC motor to rotate with...
Yes, that is what I am saying. If you have work experience as an engineer and can show accomplishments that would help, but the added post...
Matt Your response to the input you got from many practicing engineers would indicate your not absorbing the input. in today's job market as...
Re-Use I like Dana's last comment to look at existing devices for inspiration. An old VCR tape deck has a motor and caddy with gear train...
Karol If you want help you may need to supply a bit more information. For example what software are you using? I presume your not...
You mentioned your molding white metal plaques for cabin doors. Molten temperature range I would assume varies depending on which white metal is...
In the US I think this process is called tumbling and it is done usually in a plastic tank with a vibratory action that causes the media in the...
I agree with Mark The Oil Hardenable alloys are a poor choice if precision is required the tool may warp and thus require finish machining after...
Larry An interesting question, I am not sure I know what a boiler pot is! I'm guessing your wanting to develop high humidity at some elevated...
Another alternative might be to rig a cable on pulleys located inside and near the top the center pipe run attach the cable to the bottom of that...
You mentioned screw conveyor , I presume this was purchased from a company, if they are still in business do they have any suggestions on solving...
Michael I think the subject is well discussed above. The PE is nice to have but not essential for a career in the US. It does provide an...
Dhanush Stress relieving is often done to avoid or reduce warping, it is also done to reduce stress levels dangerously high that can cause...
I agree with the many replies above that this is a dangerous mechanism if not done properly 5 tons is a lot of weight . From an engineering...
I would caution the tension a fastener may exert on this style of insert if it is pulling the hex through the sheet metal it will have a good...
Perhpas the corner accuracy can be obtained by first drilling the 4 corners carefully with pecking then mill the slot. Plunge cuts are more...
I don't see the jpg perhaps I did vote? Thanks for responding. Dave
Poll access Pardon my ignorance but it would appear your poll has 5 respondents and no way to vote? Perhaps more would chime in if the method of...
Galling what is it? Harshad I am a bit late in this discussion on galling , I just wanted to correct you a bit more on this subject. Two...
Separate names with a comma.
▲
