injection moulding

Thread
Surface finish for Injection Mould tooling.

Hi, I have a received a drawing for an Injection moulded part that requires a surface finish of 'E8' to all A-side surfaces. Personally I am...

Thread by: Lee_G, Jan 28, 2019, 3 replies, in forum: Surface finishes
Thread
Surface finish for Injection Mould tooling.

Hi, I have a received a drawing for an Injection moulded part that requires a surface finish of 'E8' to all A-side surfaces. Personally I am...

Thread by: Lee_G, Jan 28, 2019, 0 replies, in forum: Surface finishes
Thread
Help Design Injection Molding Tool/Part.

Hello, This is the first Injection Molded part that I have been asked to design. So I have very little experience and have been learning most...

Thread by: GregSmith, Nov 18, 2015, 6 replies, in forum: Plastic moulding
Thread
Material for an injection moulded LIGHTPIPE?

I am designing a simple injection moulded lightpipe for outdoor use. It will channel light from an LED within an enclosure through hole to the...

Thread by: GarethW, Jul 11, 2014, 5 replies, in forum: Plastic moulding
Thread
Wanted: Injection Mold Designer

Founded in 1958, Kruis Mold & Engineering (www.kruismold.com) is a family-owned injection mold shop located in Elkhart, IN. Along with its sister...

Thread by: cburkhead, Jan 29, 2013, 0 replies, in forum: USA jobs
Thread
Injection moulded dish antenna with vacuum metalisation

I'm considering making a dish antenna (130mm diameter) from a plastic injection moulding with vacuum metalisation. Three major issues: Dish...

Thread by: GarethW, Aug 8, 2012, 7 replies, in forum: Plastic moulding

Showing results 1 to 6 of 6

injection moulding

Surface finish for Injection Mould tooling.

Surface finish for Injection Mould tooling.

Help Design Injection Molding Tool/Part.

Material for an injection moulded LIGHTPIPE?

Wanted: Injection Mold Designer

Injection moulded dish antenna with vacuum metalisation

Log in

Register

Useful Searches