• Welcome to engineeringclicks.com

    • machining m3 holes

    1. GarethW
      Thread

      M3 tapped holes - minimum pitch?

      I'm designing a part with lots of M3 tapped holes. Basically it's an aluminium block 20mm thick with lots of M3 holes on one face. What's the...
      Thread by: GarethW, Nov 29, 2011, 5 replies, in forum: Machining
    Showing results 1 to 1 of 1

    ▲

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Accept Learn More.
      Dismiss Notice