• Welcome to engineeringclicks.com
  • Bushing with 3/4-32 thread

    Discussion in 'Manufacturers of mechanical parts' started by APL, Mar 3, 2020.

    1. APL

      APL New Member

      Joined:
      Mar 2020
      Posts:
      2
      Likes Received:
      0
      Hi,

      I have been looking for something off the shelf for a while now and not been able to find anything suitable, i assume its due to the tricky thread? The external thread needs to be 3/4-32, however i do not mind if its fully threaded or only up to 5mm. The ID does not need to be threaded, only requirement is its 12mm minimum . The taper is also not a hard requirement but would be preferred.

      Please shout out if anyone has anything in mind that would be suitable.

      Cheers,
      A
       

      Attached Files:

    2.  
    3. Erich

      Erich Well-Known Member

      Joined:
      Feb 2012
      Posts:
      266
      Likes Received:
      2
      Never seen anything close to that as an off the shelf item.
      That is why people make drawings and have machine shops make parts to their specification.
       
    4. APL

      APL New Member

      Joined:
      Mar 2020
      Posts:
      2
      Likes Received:
      0
      Just checking. Cheers.
       

    Share This Page

    By using this website you agree to our Cookies usage. We and our partners operate globally and use cookies, including for analytics, personalisation, ads and Newsletters