hello everyone... refrigerant at condenser inlet are 90 degree and at outlet temp.48 degree and where as in evaporator refrigerant inlet 48 degree and i required refrigerant outlet temp.90 for condenser thermal parameters are as under wet bulb temp-43.4 degree dry bulb-25 degree, desuperheating -35 degree subcooling- 7 degree heat transfer capacity-i required 8 tr or condenser thermal parameters are as under wet bulb temp-43.4 degree dry bulb-25 degree, liquid line temp. - i taking 48 degree is this possible ( if not possible then suggest me liquid line temp.) super heating degree- i take 7 degree(if not possible then please suggest me superheating temprature) evaporating degree - i take 5 degree ( if not possible then please suggest me evaporating temprature) heat transfer capacity-i required 8 tr from above parametres there is possibility to same geometry dimension of both condenser and evaporator...?when both evaporators and condensers heat transfer capacity are same? if it is same then what is the reason ..? and it is not same then what is the reason for it please explain me..?i want to know this queary.. so please any one having a idea please send me my answer note- i required 8tr condenser and 8 tr evaporator in same geometry dimension it is possible ? yes or not and which factor are directly act on its geometry dimension if there is no geometry dimension are same so what is the reason i want first only theoritical answer not with calculation if u have perfect calculation then send me on my mail id [email protected] regards rushin patel design & development engineer [email protected]