• Welcome to engineeringclicks.com
  • Creating a Tapered Loft over Curved Rails

    Discussion in 'Autodesk Inventor' started by bobsmith, Jun 6, 2014.

    1. bobsmith

      bobsmith New Member

      Joined:
      Jun 2014
      Posts:
      1
      Likes Received:
      0
      I am struggling to connect, in an inventor model, the stem of a brake pedal to the foot pedal itself, as shown in the attached jpeg. I have tried doing a taper loft and projecting the front elevation profile onto the loft plane using a 3d sketch and then using this 3d sketch as the rails for the loft, but I cant get it to work. Does any body have any suggestions?

      M3839-2.ipt

      Motor Cycle Brake Pedal.zip
       
    2.  

    Share This Page