• Welcome to engineeringclicks.com
  • Doubts about mech software

    Discussion in '2D and 3D CAD general discussion forum' started by shaikh fazal ahmed, Aug 24, 2011.

    1. shaikh fazal ahmed

      shaikh fazal ahmed New Member

      Joined:
      Aug 2011
      Posts:
      1
      Likes Received:
      0
      respected sir,
      what is the use of learning all the mech software where one would work on one software
       
    2.  
    3. GarethW

      GarethW Chief Clicker Staff Member

      Joined:
      Jul 2009
      Posts:
      1,424
      Likes Received:
      5
      Hi, I assume you mean CAD systems? If so, I don't see the point of learning ALL of them. Just learn one to begin with. The skills are transferable to another CAD system. Once you're familiar with the process of modelling it's pretty easy to learn another CAD system.
       
    4. teja

      teja New Member

      Joined:
      Feb 2014
      Posts:
      2
      Likes Received:
      0
      sir i am having doubt on loadings on shaft.which is of slag transfer car which moves on a rail
      now there is a shaft which is having two wheels and two bearings(axle box) at ends and gear box at middle
      and my doubt is where the entire body weight act and and scrap weight i should add and where reaction forces act?
      i will be glad if you reply
      thanks
       

    Share This Page