• Welcome to engineeringclicks.com
  • Hello Everyone

    Discussion in 'Pop in and say hello!' started by Paul W, Feb 7, 2011.

    1. Paul W

      Paul W New Member

      Feb 2011
      Likes Received:
      I have found that my knowledge and that of my team at EDM Precision Technologies, can be very helpful when designers are unsure of the suitability of EDM - Electro Discharge Machining as a production process or what tolerances are suitable/achievable.

      Please feel free to ask me questions? You can also visit http://www.edmprecision.com

      Based at Silverstone UK - we do a lot of Formula 1 work so we are ready for tough timeframes and small batches.

      I am looking forward to helping where I can

      Paul Waldron
    3. GarethW

      GarethW Chief Clicker Staff Member

      Jul 2009
      Likes Received:
      Hello Paul - welcome to the Mechanical Design Forum!

      Do you have any good EDM design guides? You could post them in the Knowledge Base

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice