• Welcome to engineeringclicks.com
  • Hi to everyone

    Discussion in 'Pop in and say hello!' started by jibberjabber74, May 11, 2012.

    1. jibberjabber74

      jibberjabber74 Member

      May 2012
      Likes Received:
      Hi all

      I found this forum by googling Mechanical design forums, I have been reading some of the post and thought what a good site to get into for knowledge and maybe help others.

      My background is 15 years experience sheetmetal fabrication and welding and 2 years Cad draughting, I am due to complete a Higher national diploma in Mechanical design engineering.

      I am and have been trying to find a job as a design engineer for some time to no prevail, I was wondering if anyone has any advice how to go about doing this, I am after preferably entry level roles, but would a direct entry into a sector close linked to my sheetmetal fabrication experience and HNC suffice to start a career as a design engineer

      Many thanks

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice