• Welcome to engineeringclicks.com
  • Ingress Protection IP69K

    Discussion in 'The main mechanical design forum' started by Sword, Aug 9, 2012.

    1. Sword

      Sword Member

      Joined:
      Aug 2012
      Posts:
      11
      Likes Received:
      0
      Hello,
      Thank you everybody for your help, I have done this product with an O-ring gasket and the test of IP6K9K was successfully done :cool: :cool:. So, If some one want to make a product with IP69K I propose to make:
      1- An O-ring gasket.
      2- Walls that will mitigate the water jet.
      3- Maximum distance between screws should be equal to 60mm. :)
       
    2.  

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice