• Welcome to engineeringclicks.com
  • Large Diameter Seal - 700 bar

    Discussion in 'The main mechanical design forum' started by hdalzd, May 1, 2022.

    1. hdalzd

      hdalzd New Member

      Joined:
      May 2022
      Posts:
      1
      Likes Received:
      0
      Hi
      I am going to design and manufacture a very low speed hydraulic cylinder which diameter of cylinder bore is 950 mm, rod diameter 650 mm, stroke is 30 mm and the operating pressure is 700 bar. it will be appreciated if you can provide me information about suitable sealing product and groove dimension, tolerance and radial gap with references and standards.
      I find this type of piston seals on internet. but there isn't any information for required diameter. Capture.JPG
       
    2.  

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice