• Welcome to engineeringclicks.com
  • MTS RPC latitude and longitude data

    Discussion in 'The main mechanical design forum' started by inamukak, Mar 18, 2014.

    1. inamukak

      inamukak Member

      Joined:
      Feb 2014
      Posts:
      6
      Likes Received:
      0
      Hey everyone!

      I was trying to isolate data from time histories in MTS RPC based on latitude and longitude of the position the data was collected at but am not sure of how to go about it. I opened up the statistical region selector and tried to set up an operation that could do it, but so far all I have been able to do is separate regions from the time histories of just the lat and the long but not the others.


      Any help here would be greatly appreciated. Thanks in advance!
       
    2.  

    Share This Page