• Welcome to engineeringclicks.com
  • Need help on a question assembling a centrifugal

    Discussion in 'The main mechanical design forum' started by steenoo, Jun 2, 2013.

    1. steenoo

      steenoo New Member

      Joined:
      Jun 2013
      Posts:
      1
      Likes Received:
      0
    2.  
    3. Dana

      Dana Well-Known Member

      Joined:
      Sep 2010
      Posts:
      341
      Likes Received:
      3
      You might get more responses if you don't link to pictures on facebook. Put the pictures right in the message here. Many of use can't or won't access facebook at work.
       
    4. WScarbrough

      WScarbrough New Member

      Joined:
      Jun 2013
      Posts:
      1
      Likes Received:
      0
      2-11-4-1-12-(13+14)-6-3-8-7-(5+9)

      I would assemble the deep bearing (on the left in your drawing) first, because access is limited in that area...

      Without know specifics of your design intent, I would have mounted the bearing (4) into a different design of the retainer (13). It could then be bolted on in one sub-assembly.
       
    5. Francois

      Francois New Member

      Joined:
      Jun 2013
      Posts:
      3
      Likes Received:
      0
      2-11-4-12-13-1-6-3-8-7-5-9-14
       

    Share This Page