• Welcome to engineeringclicks.com
  • Need someone better at math :)

    Discussion in 'The main mechanical design forum' started by JC_Biggs, Jan 20, 2011.

    1. JC_Biggs

      JC_Biggs Active Member

      Joined:
      Jan 2011
      Posts:
      25
      Likes Received:
      0
      i do have solidworks. the rollers cant change their distance apart so the thickness of the plate has to change. i still need a way to figure what line i should draw to extrude the surfaces to.
       
    2.  
    3. maniacal_engineer

      maniacal_engineer Well-Known Member

      Joined:
      Jul 2009
      Posts:
      137
      Likes Received:
      0
      my e-mail is maniacal(underscore)engineer(at)ez2(dot)net Send me a message and I will send you my model. The one I modeled has one cycle per rev, but I could adapt it to any number if you needed it.
       

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice