• Welcome to engineeringclicks.com
  • Shaft loads static or fatigue calculation ?

    Discussion in 'The main mechanical design forum' started by Yuri, Dec 11, 2013.

    1. KevinC

      KevinC Well-Known Member

      Joined:
      Jun 2011
      Posts:
      72
      Likes Received:
      0
      If it doesn't get to much cyclic loading (reversal loading), then just do static calculation would be good. Other wise, unless your loading statically is higher than your dynamic loading, you should do fatigue analysis.
       
    2.  

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice