• Welcome to engineeringclicks.com
  • Sports HeadGear Foam

    Discussion in 'The main mechanical design forum' started by wizardofid, May 17, 2011.

    1. wizardofid

      wizardofid Active Member

      Sep 2009
      Likes Received:

      I'm looking for a foam similar to the one used in this mountaineering helmet, though not for the same application
      http://www.simond.com/shop/activities/a ... et---Grey/

      This is a single piece foam with a gloss exterior surface. Is this made by an integral skin method? Also we need to stick a few 10gm parts to the foam that cannot be moulded in. We've had a bit of bother with finding the right adhesive. It would be great to get specifications for the foam, skin/ surface treatment, and any adhesive that the foam can take.

      And a source that that mould 250~700gms in China/ India/ Indonesia/ Thailand would be a great bonus.


    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice