• Welcome to engineeringclicks.com
  • Stamping Titanium Grade 2

    Discussion in 'Manufacturers of mechanical parts' started by Noel.Farrell.Infinity, Nov 8, 2022.

    1. Noel.Farrell.Infinity

      Noel.Farrell.Infinity New Member

      Nov 2022
      Likes Received:
      I'm working on a project that requires us to produce a rather complex geometry from titanium grade 2. I assume stamping is the best bet in this case, but I'm concerned that it might be difficult given the strong mechanical properties of titanium. The real question I have is something like this possible with stamping? If not, what process would be best? We are already producing these parts via machining, looking to move away from this to a cheaper more mass producible process.

      See the attached images of the approx intended design.
      Also, just to note there are no rad's included in the CAD but obviously they would be needed.

      Attached Files:


    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice