• Welcome to engineeringclicks.com
  • Surface finish for Injection Mould tooling.

    Discussion in 'Surface finishes' started by Lee_G, Jan 28, 2019.

    1. Lee_G

      Lee_G New Member

      Joined:
      Jan 2019
      Posts:
      2
      Likes Received:
      0
      Hi,

      I have a received a drawing for an Injection moulded part that requires a surface finish of 'E8' to all A-side surfaces.

      Personally I am only familiar with the SPI fininishes i.e. A-1, A-2, etc through to D-3, Would someone be able to tell me what E8 is equivalent to or direct me to where I could find relevant information on such grades?


      Thanks in advance,


      Lee
       
    2.  

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice