• Welcome to engineeringclicks.com
  • Swivel arm for a homebuilt foam cutter

    Discussion in 'Joining & fabrication' started by tomcatonnet99, Aug 16, 2014.

    1. tomcatonnet99

      tomcatonnet99 Member

      Aug 2014
      Likes Received:

      I am a novice to this field so am hoping someone could point me in the right direction. I have designed a foam cutter with swivelling wooden arms running in a channel in a fixed wooden arm.

      Currently using a sort of a flanged nut and bolt with washer to connect the arms but that makes the swivel action either too stiff or too loose and has a bit of play in it... how best do I connect the swivel arms please ( I am looking for a cost effective and yet an acceptable level of near play free and smooth swivel action)

      dimensions : each wooden arm is 3cm wide x 1cm deep (thickness)

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice