• Welcome to engineeringclicks.com
  • What version of Pro/E came out after Wildfire 4?

    Discussion in 'Creo or Pro/Engineer' started by Tunalover, Jun 15, 2014.

    1. Tunalover

      Tunalover Member

      Joined:
      May 2014
      Posts:
      9
      Likes Received:
      0
      The last time I used Pro/E in a substantial way was when it was at Wildfire 4. What version came after Wildfire 4? I don't recall pin constraints then but saw mention of them in a recent post. What version did pin constraints appear in?
      Thanks!
       
    2.  
    3. cam2248

      cam2248 Member

      Joined:
      Feb 2013
      Posts:
      10
      Likes Received:
      0
      It was there in Wildfire 4 but as a mechanism, not a constraint. Probably still that way.
       
    4. Strider

      Strider Member

      Joined:
      May 2014
      Posts:
      17
      Likes Received:
      0
      Pin constraints have been part of "foundation" ProE since at least WF4. I'm on Creo3.0 and it's still there.
       
    5. Strider

      Strider Member

      Joined:
      May 2014
      Posts:
      17
      Likes Received:
      0
      To answer the question, Wildfire 5.0/Elements came after WF4.0. Then came Creo 2.0 and as of last Friday Creo 3.0 (beta version has been out for a few months already).
       

    Share This Page